Now under firmware version, choose LINX - WiFi.Įnter your network information including SSID, password type, password, port, and IP address for your WF32. Now choose the COM port that the WF32 is connected to. Choose Digilent, chipKIT WF32, and Serial/USB. Open LabVIEW and under tools, click MakerHub -> LINX -> LINX Firmware Wizard.
![how to install labview drivers how to install labview drivers](https://lavag.org/uploads/monthly_01_2016/post-54428-0-58591500-1454168438.jpg)
To set up WiFi on the WF32, you need to deploy the WiFi firmware. Again, if you're having trouble with these steps, check out the guide on LabVIEW MakerHub for step-by-step video instructions.Īfter the firmware wizard is finished, click on launch example. The firmware will then be transferred to the WF32 and the on-board lights will flash. Click next and then choose LINX serial/USB and click next again.
![how to install labview drivers how to install labview drivers](https://www.mccdaq.com/images/photos_500/ulx-lv_500.jpg)
Choose the COM port that the WF32 is connected to. Choose Digilent from device family and choose chipKIT WF32 from device type and click next (pictured above). Now, launch LabVIEW and click tools -> MakerHub -> LINX -> LINX Firmware Wizard to deploy the LINX firmware to the chipKIT. Under the BM options, change the latency timer to 1 ms.
![how to install labview drivers how to install labview drivers](https://www.kvaser.com/wp-content/uploads/2014/01/labw1.jpg)
#How to install labview drivers drivers#
With the drivers installed, right click on the COM port for the chipKIT WF32 and click properties then click on port settings and choose advanced. If the drivers were not installed properly, download the drivers for your device which are included as part of MPIDE found here. The COM port is the chipKIT WF32 and if the drivers were not installed correctly, a yellow exclamation mark will appear over the device. To make sure drivers are installed correctly, open the device manager from the control panel and expand the Ports section. With all the required software installed, connect chipKIT WF32 to your PC using a USB A to mini B USB cable.